Wednesday, 19 September 2012

Solid Surface Renos 7

Finally starting to look like something...

I disconnected the old sink, including the garburator. (I made sure the new sink would line up so I wouldn't have to change the drain pipes. It's 1 inch deeper but still fits as the countertop itself is a bit higher.)

Time to take out the old tops! There's a few screws from below.

Routering the drain board with a half-moon type router bit. I shimmed up the straightedge on one end to make a trench that gets deeper towards the sink, helping the water drain away from the countertop.

No comments: